Posts Tagged ‘zoning’

Dell MXL and FC Flex IOM: Enabling Network Convergence via FCoE [Video]

Saturday, February 8th, 2014

As you know from my prior blog, blog, the Dell FC Flex IOM adds 4 x FC ports (8 x FC ports with 2 modules) to the Dell MXL/IOA blade switch and transforms it into a NPIV Proxy Gateway (NPG) allowing for the bridging of FCoE and Fibre Channel at the switch blade level. Check-out the video here on YouTube (also embedded below) or on the Dell MXL wiki page (second video on page) that steps through the details and ease of deployment of this solution. (more…)

Twitt

Dell PowerEdge M1000e – FlexAddressing

Friday, January 31st, 2014

Dell PowerEdge M1000e as shown with detected blade servers in the Dell M1000e Chassis CMC GUI

Dell PowerEdge M1000e as shown with detected blade servers in the Dell M1000e Chassis CMC GUI

Let’s say you have a Dell PowerEdge M1000e chassis populated with Dell blade servers with CNAs. Let’s also assume you enable FCoE on the CNA and utilize it for LAN and SAN traffic.

What if you were to use the CNA port’s WWPN (World Wide Port Name) within your zoning configuration on a backend Fibre Channel switch? What would occur if the CNA adapter went bad and needed to be replaced? Well, you would have to manually change all configurations that reference the LAN MAC Address or FC WWPN. In this case, the zoning configuration would have to be updated. This is where Dell’s M1000e FlexAddressing technology can help. (more…)

Twitt