Posts Tagged ‘Dell PowerEdge M1000e’

Network Virtualization with Dell and VMware NSX [Video]

Thursday, August 28th, 2014

Check out my latest Dell Networking video on Network Virtualization with Dell and VMware NSX. You can view it on the Dell VMware wiki site, the Dell YouTube channel, or see the video embedded below via direct link. (more…)

Twitt

Dell PowerEdge M1000e – FlexAddressing

Friday, January 31st, 2014

Dell PowerEdge M1000e as shown with detected blade servers in the Dell M1000e Chassis CMC GUI

Dell PowerEdge M1000e as shown with detected blade servers in the Dell M1000e Chassis CMC GUI

Let’s say you have a Dell PowerEdge M1000e chassis populated with Dell blade servers with CNAs. Let’s also assume you enable FCoE on the CNA and utilize it for LAN and SAN traffic.

What if you were to use the CNA port’s WWPN (World Wide Port Name) within your zoning configuration on a backend Fibre Channel switch? What would occur if the CNA adapter went bad and needed to be replaced? Well, you would have to manually change all configurations that reference the LAN MAC Address or FC WWPN. In this case, the zoning configuration would have to be updated. This is where Dell’s M1000e FlexAddressing technology can help. (more…)

Twitt

Stacking the Dell MXL Blade Switch

Friday, April 5th, 2013

Dell MXL blade switch

Dell MXL blade switch

The Data Center Bridging (DCB) enabled Dell MXL blade switch provides a 1/10/40GbE upstream solution for the Dell PowerEdge M1000e chassis. It comes with two fixed 40 GbE ports but is scalable up to six 40GbE ports via 40GbE FlexIO modules; this provides a total of twenty four 10GbE ports from a single blade switch using breakout cables. Other FlexIO modules available for the two FlexIO ports are a 4 port 10GbaseT module and a 4 port 10GbE SFP+ module. One Dell MXL switch can provide up to 32 line-rate 10GbE internal-facing ports for Dell blade servers. Additionally, using the 40GbE ports, 6 MXL blade switches can be stacked together. In this blog I will demonstrate how to stack 2 Dell MXL blades together. (more…)

Twitt

Connecting Dell PowerEdge M I/O Aggregator with Dell Force10 S4810 and Cisco Nexus 5548UP

Monday, February 11th, 2013

Dell PowerEdge M I/O AggregatorThe Dell PowerEdge M I//O Aggregator is a slick blade switch that plugs into the Dell PowerEdge M1000e chassis and requires barely any configuration/networking knowledge. Think of it as an advanced layer 2 switch that provides expandable uplink connectivity. The base blade comes with 2 x 40 GbE ports that by default are configured as 8 x 10 GbE ports. If desired, these ports can also be used as 40 GbE stacking ports. The Dell PowerEdge M I/O Aggregator also provide 32 internal 10 GbE connections for Dell blade servers you can install in the Dell PowerEdge M1000e chassis. If quarter-height blade servers are used, the M1000e can support up to 32 servers. This is pretty cool, not only in terms of functionality, but also in terms of the consolidation and the mess of Ethernet/power cables avoided by not using standalone components. (more…)

Twitt